Laser galvanometer scanner is a device with a precise design structure, and continuous working for a long time will cause the temperature to rise, which will affect the use effect to a certain extent. Therefore, when using a laser galvanometer scanner, attention should be paid to its correct operation.
1. Doing a good job of heat dissipation is an effective way to maintain the laser galvanometer scanner. So when installing a professional laser galvanometer scanner, care must be taken not to place the air inlet and outlet too close to the casing, and to leave a certain space for air to circulate. In addition, a cooling fan should be installed inside the chassis, and the air conditioner should be used to cool down when the ambient temperature rises, to ensure that the laser galvanometer can dissipate heat well during operation, so as to avoid high heat from adversely affecting the equipment.
2. During routine maintenance, pay attention to cleaning the dust on the laser galvanometer scanner, and regularly use an air gun to blow out the dust on the air inlet and outlet of the laser galvanometer. At the same time, clean the dust net on the cabinet to prevent the laser galvanometer scanner air outlet. Blocked by dust and affecting equipment heat dissipation.
3. If the lens of the laser galvanometer scanner needs to be cleaned, use an ear wash ball to blow the lens until The surface of the lens is free of particles. Then use a special cotton swab dipped in laboratory-grade acetone and ethanol to wipe gently. If you use lens cleaning paper, stack the lens cleaning paper into small squares and sandwich it between your four fingers to moisten it, and then wipe it lightly in the direction of the laser scanning lens coating texture.
Through the introduction, we can roughly divide the maintenance of laser galvanometer scanner into three parts, that is, do a good job in heat dissipation, dust removal, and cleaning and care of the lens. As long as these three parts are done daily, the equipment can be maintained and its service life can be extended. Of course, if you want to have a high-quality and long-life laser galvanometer, you must not only do good maintenance, but also pay attention to purchasing from the most professional company of laser galvanometer scanner.
Sino-Galvo Tech. was founded in 2001, is a hi-tech enterprise that devotedly integrates R&D, manufacture and sales of galvo scanner as well as control systems for industrial and medical field. Due to endeavor by its 200+ working staff, Sino-Galvo, occupying an area of 10,000㎡, has now made it to the biggest hi-performance galvo scanner production base of all. The product covers full series of galvo scanner with 3mm-50mm beam aperture, and our annual sales is above 70,000 units, while the repair rate is less than 1%.
Welcome to consult: 400-055-8805
