High Accuracy 10mm Galvo Head

System has no any reactions

No power supply or the circuit did not connect well.

Check if the power supply is connected well

Red light keeps on with   "KaBa" sound

Position limitation protection

Check if over input signal   amplitude. If the signal is normal, please contact us.

Scan motor swings lightly after turning on

Too much interference or input signal circuit did not   connect very well

Check the interference sources and the input signal circuit

Motor squeals after turning on, the drive board and   motor overheat

Driver board and motors did not connect well/The   mirrors or clips become loosen.

Check the wiring/ the mirrors and clips.

Mirror reflection power is weak

Light path is not aligned well

Align the light path of the marking machine; If the   light path is normal, please contact us.

Marking graphics becomes one straight line

One motor can not move normally

Checking the wiring connection between the motors,   drive boards and control board

Waves exist in the marking line

Grounding problems/

Surrounded by strong interference sources/The   Anti-interference ability of marking control board is poor

Check if the ground connection is well/Check if there   is a strong interference source surrounded/

Check the position control signal of marking control   board

Marking square becomes rhombus or one side not straight

Abnormal signal output   from D/A board.

Replace D/A board, if not   solved, please contact us.